Introducing Squeeeeek No More® floor repair kit

Installation guide
The easy to use Squeeeeek No More repair kit is perfect for fixing both squeaky and/or warped floors in hard to reach places like on the second story, or in apartments where your neighbor below might have a problem with your tearing through the ceiling (go figure). It's actually so simple to install that anyone can do it. We provide all the hardware and fixtures and the only thing you'll need is a squeaky floor and a power drill to drive in the patented snap-off screws.

  Step 1: Locate the squeak, and place the alignment and depth control fixture over the squeak (included with kit). Press the fixture down into the carpet firmly and proceed to step 2.

  Step 2: Place your feet on either side of the fixture as close as possible. Place a screw on the tip of the driver bit and guide the screw into the barrel of the alignment and depth control fixture. Next, with the power screw driver in the forward position, drive the screw down until it reaches the alignment and depth control stop. Then proceed to step 3.

  Step 3: Remove the fixture from the floor and use it to snap off the head of the special screw. You will have eliminated the squeak and will not be able to fnd any indication as to where the screw was placed. Standing on the area, you will notice that the floor is solid and you will not be able to feel anything in the floor.